XHORSE ESL Emulator for Benz 204 207 212
- Most W204 W207 W212 ESL will damage with EIS. In this case, there are two possible reasons and solution:
- ESL motor is damaged and need to replace a new motor
- NEC chip is locked, theoretically it can be unlock, actually it needs to replace new ESL.
Work with VVDI MB tool
How to tell if the ESL is damaged or NEC is locked?
If you have any problem, please feel free to contact us.Contact Information:Skype: VVDIfactory.comWhatsapp
Open VVDI MB Tool software, Click “Check ESL damage” and you will get any of following display:
ESL is working: means the motor is damaged and you need a new full set of ESL motor.
ESL is damaged:
need to replace new ESL.
How to replace ESL with VVDI MB BGA Tool?
Erase EIS, then re-write EIS and personalize ESL, finally ESL is synchronized. Note: if you not erase ESL at first, but only personalize ESL, the ESL won’t be synchronized.
To erase EIS, both Key password and Erase password are required.
1) For the key password, you can get it by adding keys.
Now the EIS is full new
Load EIS data
Tick "IR" to write EIS data and "OBD" to write VIN.
Click “Personalize W204 ESL”
Now, the options "Initialized", "TP Cleared" and "Personalized" are ticked, except “Activated”
Insert the original car key then EIS and ESL is in “Activated” status.
Finally renew ESL with success.
It's hard to buy Mercedes 204/207 EIS and they are expensive. If you have 204/ 207 all key lost, you are advised to use W212 EIS for replacement and the ESL needs to be removed.
1pc x ESL Emulator for Benz 204 207 212
: +86 13559259147
Replace Mercedes ELV by VVDI MB BGA Tool
How to install ELV Emulator by VVDI MB Tool
1.Connect EIS,Xhorse ELV Emulator.
2.Start VVDI MB Tool Software.
3.Clikc ESL Tool,choose chasis,and OBD way,then press Read ESL Data.
4.After read esl data,tick off Personalized and Activated option.
5.Click “EIS Tools” on the left,choose OBD way,and Chasis type to read EIS Data.
6.Click Get to erase EIS key password.
7.Paste key password,then save EIS data.
8.Press OK to save HC05 format file.
9.”EIS Tools” page,choose IR mode,and click “Renew EIS”,then insert IR key to EIS.
10.Insert IR adapter to car. Take out and insert again if it is already inserted. Wait about 28 seconds until erasing EIS success
11.Select OBD mode,click “Read EIS data”.Reading data success, EIS is normal.
12.Click Load EIS data,and please open EIS data saved previously.
13.Click Write VIN.Please confirm VIN and click Yes to continue.
14.After write VIN success.Choose IR model,select Write EIS data,then click YES
15.Please wait until Writing data success.Select OBD mode,and click Personalize W204 ESL.
16.ELV is personalized.