Xhorse Dolphin XP005L TOY40 ‘Error Code:33” Solution

---

The TOY40 emergency key is very thin, only 1.5mm with one side. So if using 2.5mm cutter, Xhorse Dolphin XP005L will give a 33 error code. Following I’m gonna show how to decode & cut it.

For Dolphin XP005 or Condor XC-Mini Plus key cutting machine, you’ll need to use M2 clamp & bar adapter. New Dolphin II M5 clamp can cut without bar adapter.

Decode Key

Vehicle database >> Asia >> Toyota >> TOY40 emergency key(one side key)

Install the original key on M5 clamp side B, tip align 2nd position.

Press “Decode key”.

The Dolphin II will start decoding, just wait until completed.

Its bitting codes have been read out.

Cut Key with 1.5mm Cutter

Install new key blank on M5 clamp, press “Cut key”.

It mentions “Error code:33, cutter diameter tool large.” while the warning red light is flashing. That means the TOY40 one side key cannot use with 2.5mm cutter.

So let’s change the cutter to 1.5mm.

And remember to save new cutter diameter on machine:

System >> Machine parameter >> Cutting setting >> Cutter diameter: 1.5mm

Go back to re-cut again.

Xhorse Dolphin II can normally cut key now…

Cut key success.

Done.