VVDI Prog BMW CAS4 No Remove Component Pinouts
Xhorse VVDI Prog V4.8.8 adds BMW CAS4 1L15Y 5M48H read/write without removing components.
+ Add CAS4-1L15Y-CERAMICS, CAS4-1L15Y-METAL-NO-NEED-REMOVE-COMPONENTS PICTURE in<4-IMMOBILIZER>->->
+ Add CAS4-5M48H-CERAMICS, CAS4-5M48H-METAL-NO-NEED-REMOVE-COMPONENTS PICTURE in<4-IMMOBILIZER>->->
+ Add CAS4-5M48H-CERAMICS,CAS4-5M48H-METAL-NO-NEED-REMOVE-COMPONENTS PICTURE in<4-IMMOBILIZER>->->
+ Add CAS4-5M48H-CERAMICS,CAS4-5M48H-METAL-NO-NEED-REMOVE-COMPONENTS PICTURE in<4-IMMOBILIZER>->->
+ Add CAS4-5M48H-CERAMICS, CAS4-5M48H-METAL-NO-NEED-REMOVE-COMPONENTS PICTURE in <4-IMMOBILIZER>->->
+ Add CAS4-5M48H-CERAMICS, CAS4-5M48H-METAL-NO-NEED-REMOVE-COMPONENTS PICTURE in <4-IMMOBILIZER>->->
VVDI Prog BMW CAS4 No Need Remove Components Wiring Connections
Customer feedback:
I tested new update CAS4 5m48h:
without removing any component – read backup FAIL to crack
with removing only 1 resistor – read backup SUCCESS
green soldered wrongly
green wire need connect to other side of resistor (check from vvdi prog diagram)
That’s very good job by xhorse.
Xhorse engineer Samic’s suggestion:
mostly of those types no need to remove components, but maybe few of CAS4 the component affected on clock signal, better to remove it if crack failed.
