VVDI Key Tool Plus Pad Bypass 2017- Jeep Compass IMMO via FCA Adapter

---

Xhorse VVDI Key Tool Plus Pad has the advantage of reading PIN code and programming key for 2018- Jeep car models via OBD. Check the newest test report on Jeep Compass ID4A (Keyless Go) smart key programming using this all-in-one key programmer with FCA 12+8 universal adapter.

Why need FCA 12+8 universal adapter?
All 2018 FCA (FIAT/CHRYSLER/ALAFA ROMEO) vehicles are equipped with SGW safety gateway modules to prevent access to the vehicle from the OBD2 port via a non-original diagnostic scanner. The purpose of the FCA 12+ 8 Universal Adapter cable is to prevent attacks on the vehicle network via CAN bus.

There are two FCA 12+8 Adapters for selecting.
Option 1:  OBDSTAR FCA 12+8 ADAPTER
Option 2: Autel FCA 12+8 Adapter Cable

How to use FCA 12+8 Universal Adapter?
1.Locate and unplug the 12pin and 8PIN connectors of the SGW module.
2.Then connect the FCA 12+8 directly to the 12pin and 8pin (two connectors connected to the SGW) connector on the car.
Note: the gateway connector is generally behind the CD player (Commander, Cherokee), under the co- pilot glove box (Grand Cherokee), and under the steering wheel (Compass, Wrangler)
 
3.At this point, normal communication with the car can be achieved.
Refer to the following connection to connect FCA 12+8 adapter to 2018- Jeep compass car.
 
4.Connect the OBD connector of FCA 12+8 universal adapter cable to Xhorse Key Tool Pad OBD cable

Main steps to add new smart key to 2017- Jeep Compass:
Step 1: Program remote
Put the key into the coil of KeyTool Plus
Go to “Remote Program” function
 
Select All brands-> Jeep-> Compass-> Compass (2017+) keylessGo ID4A
Tap “Generate” Burn successfully
Step 2: Program smart key
Go to “Immo Programming” function
Select All brands-> Jeep-> Select from model-> Asia-> Compass-> 2017- -> Keyless Go
Tap “Start programming” Select “Program smart key” Switch ignition off, turn on the security warning light (double flash lights)
Make sure there are no wireless devices near the smart key
Keep the smart key to be programmed close to the central console (or start button), then press and release UNLOCK button on the remote once and wait for 5 seconds, do not press any button during this time.
Note: The new key must be the original key of the current model, otherwise the program may fail.   Match the key successfully, and the current key number is 2. Finally, use the key to test the remote and start car, both work well. Awesome! VVDI KeyTool Plus Pad program smart key to 2017- Compass successfully.