A:
Xhorse BIMTOOL Pro has two ports: USB and Ethernet port.
For 10/100M programming, BMW ECU programming (NBT/CIC), BMW E-Sys and Rheingold Diagnostic system, F/G Chassis programming
How to use:
1.Connect VVDI BIMTOOL Pro to computer Ethernet interface via internet cable
And connect to the car or test platform to supply power
2.Open BMW Tool software to check the connection status
3.When connection is normal, it will show “connect 2: OK” and show the corresponding IP address.
Q: When to connect with USB port?
A: For FEM/BDC programming and other functions
When the connection is normal, it will show “connect 1: OK”.
Please kindly notice:
Don’t use USB cable and internet cable to connect BIMTOOL Pro and computer at the same time, otherwise it will fail to use!
Q: I installed all the Xhorse VVDI BIMTool pro software but nothing is working and tool always says booting.
A: Update vvdi bim tool pro firmware to latest version via Xhorse upgrade kit.
Q: VVDI BIMTool Pro Failed to update using Upgrade Kit V1.7.3
It appears a series of errors as below:
1.Error: Failed to read device info
2.Select device not found, please try to replug device
3.Failed to check device connection status and check driver version
A:
The solution:
Check if there is a new COM port in [Device Manager].
If not, please try to do as follows:
1.Turn off the anti-virus protection in Windows security
2.Download the BMW Tool software again
3.Change another USB cable to try again.
Q: Xhorse VVDI BIMTOOL Pro cannot test frequency
After plugging it into the bimtool pro detection coil, and press the F button, it cannot detect. But it can read chip data successfully. Press the key button, and test two keys, but still fail to test the frequency.
A:
It’s suggested to update the firmware to solve the problem.
Method 1: use the Upgrade Kit to update the firmware and try to operate again.
->>Connect Xhorse BIMTOOL Pro with computer via USB cable and install the device driver.
Note: Make sure the computer network connection is normal.
Method 2: free download VVDI BMW Tool V1.6.2 and update firmware via WiFi.